i'm pretty sure what to do but just want some backup on repairs of the following:
on the gray hull (no where near the tubes), i have 2 or 3 scratches that appear to have dug into the material more than just a little. they are only 1-2 inches long and i cannot see the scratch from the inside. more concerning is a puncture, very small in diameter, but i CAN see the puncture on the inside.
SO, to repair, do i just need to use the provided kit, cut some of the gray material, adhere the patches to the outside only for the scratches and BOTH sides for the puncture? i read about letting the glue cure for 6 hours before use. do i need that seal tape sold in marine stores?
thanks for any input.
ps: my boat was manufactured in 09, and never used until i bought it this summer. is the glue still good?
repair question
-
- Posts: 152
- Joined: Wed Jan 25, 2012 9:39 am
Marc, if it was me, I would just get myself a tube of Aquaseal and apply a small amount to the damaged areas, filling in any deep scratches and sealing the small puncture. If you wanted, you could also apply a little to the inside of that small puncture, just to be sure. I don't believe there is a need to put a patch on it. If you don't have a local source for Aquaseal, it can be found on ebay for about ten bucks or less. Let it dry for about 24 hours before using the kayak again.
-
- Posts: 16
- Joined: Sun Jun 17, 2012 5:04 am
- Location: Columbia, SC