What is the best way to inflate the dropstich floor?
The double action pump I use to inflate the kayak dos'nt fit the floor valve.
Thanks
inflating dropstich floor
Moderator: JCOOLEY
Contact the dealer you bought it from to see if they have the adaptor that attaches to the pump and also to the valve. If not, contact info@advancedelements.com
My ds floor came with an adapter that fits the valve. However, when the gauge on the pump (the yellow ae one) reaches almost 4 psi the adapter and valve start whistling and eventually want to pop off. is the seal not good or is 4 psi all it can really take? the floor is definitely hard at this point but should it be 6 psi harder?
How exactly should the floor be fitting inside the kayak? Under the main tubes on either side and then almost under/kinda under or not under the tubes in the bow and stern areas?
I'm still getting the valve wanting to pop off when the psi reach just under 4 psi. It's as if it doesn't lock in place very well or the gauge on the pump is inaccurate and the 4 psi reading is much greater.
I'm still getting the valve wanting to pop off when the psi reach just under 4 psi. It's as if it doesn't lock in place very well or the gauge on the pump is inaccurate and the 4 psi reading is much greater.