AirFusion Skeg- model AE4002

As new AE stuff is set to come out, we will keep you updated. Time to get EXCITED!

Moderators: JCOOLEY, rsimpson, rlpugh1

Post Reply
rsimpson
Site Admin
Posts: 203
Joined: Tue May 20, 2008 10:15 am
Location: Bay Area

AirFusion Skeg- model AE4002

Post by rsimpson » Wed Dec 21, 2011 12:34 pm

AIRFUSION SKEG
model AE4002
MSRP $69.99

Easy to use stationary Skeg for the AirFusion kayak. Simply install on the kayaks rear end cap, run the pull line, and you are ready to go. Enhances tracking and designed to pivot upward with integrated pull line.

Image

Tee Loo
Posts: 25
Joined: Tue Sep 06, 2011 4:46 pm
Location: Netherlands

Post by Tee Loo » Wed Mar 21, 2012 11:00 pm

How does the skeg pivot?
Is it spring loaded up, and so pulled down into the water?
Can I easily move it up and down just by the single cord? Is tension on the cord required to keep the rudder in place?

Thanks
Tee

rsimpson
Site Admin
Posts: 203
Joined: Tue May 20, 2008 10:15 am
Location: Bay Area

Post by rsimpson » Thu Mar 22, 2012 11:54 am

Pivots by pulling the line. Not spring loaded. To keep the skeg up, you will need to pull the line and tie it off.

Tee Loo
Posts: 25
Joined: Tue Sep 06, 2011 4:46 pm
Location: Netherlands

Post by Tee Loo » Thu Mar 22, 2012 12:11 pm

Mh... I am still a bit confused on how it works.

So what you are saying, is that the skeg normally is fully down and you need to pull the line to bring it up and hold/tie off to keep it up.

What keeps it down when kayaking? Won't the water resistance push the skeg upward or is there too much friction in the hinge? I presume the skeg does go up when you hit the ground (shallow waters).

So does the skeg lower when the line is loosened?

Sorry for all my questions, I just like to know how it technically works.

rsimpson
Site Admin
Posts: 203
Joined: Tue May 20, 2008 10:15 am
Location: Bay Area

Post by rsimpson » Fri Mar 23, 2012 1:07 pm

The skeg has a small bungee that locks it in the down position.

Post Reply